![]() The later series doesn't depends on the resolution. The screen resolution only applies to Intel HD Graphics 30. If your screen resolution is 1366x768, use that one. Suppose, if your laptop uses Intel HD Graphics 520, then select "config_HD515_520_530_540.plist". You can look at the ist and select the appropriate ist according to your graphics and screen resolution. It's easy to select among the list of ists. You can select a ist which matches to your hardware from his repository. Once again, Thanks to RehabMan who made this easy for us. You'll need to configure the ist according to your hardware, mainly graphics and other devices. This ist cannot be used to boot most of the laptops. When installing Clover, it places a default ist file. If you're using a M.2 SSD, and plan to use Sierra, read the NVMe compatibility covered in FAQ:.This will fix the above mentioned issue(No drives detected at Disk Utility). If you have an unsupported SATA controller (8086:a103, 8086:9d03), use SSATA-unsupported.kext.This can fix no drives detected at Disk Utility. If your SATA uses RAID mode instead of AHCI mode, you'll need to use an injector.You do not need these kexts for booting the installer. The VirtualSMC package includes Battery and Sensors plugins (SMCBatteryManager.kext, SMCDellSensors.kext, SMCLightSensor.kext, SMCProcessor.kext, and SMCSuperIO.kext).You can install the rest required kexts at the time of post-installation. Only use basic kexts which is required to boot off the installer.Navigate to /EFI/CLOVER/kexts/Others/ and place all the 5 kexts (Lilu.kext, VirtualSMC.kext, WhateverGreen.kext, USBInjectAll.kext, and VoodPS2Controller.kext) Use the kext from RELEASE folder and RELEASE.zip file.Ĭopy all the kexts from the release folder downloaded above.Download the latest version for better support.The pre-built binaries/downloads are available in the README.md section. ![]() Remove all the folders, 10.x, except ' Other'. Follow the guide below to place the necessary kexts. In order to boot into the installation, you need to place the necessary kexts. After installing the Clover bootloader, the EFI partition should be mounted on your Desktop. Now you’ve successfully installed clover and the required drivers on your USB.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |